MUGEN O-MCP023L Factory Pro Graphite Front Upright Lever - Precision Race Part  [FP-O-MCP023L]

Price:
£6.51
Brand:
Factory Pro
Model:
FP-O-MCP023L
Condition:
Brand New
Write a review

Engineered Graphite Upright for MUGEN MTC3

This Factory Pro O-MCP023L graphite front upright lever is made to improve steering accuracy on the Mugen MTC3. The single-piece graphite construction reduces unwanted flex while keeping weight low for steady handling during race runs.

What tools are needed to fit this upright?

Basic hex drivers and pliers are usually enough. Make sure to check fastener torque and replace any worn screws or bearings during the swap.

Will this be lighter than stock parts?

Graphite typically reduces mass compared to heavier materials, which can improve steering responsiveness, though exact weight depends on the original component.

Is modification recommended for fitment?

This item is designed for the MTC3 layout. Avoid trimming unless you have experience, and prefer model-specific parts to maintain geometry.

How do I check for damage?

Inspect for surface splintering, delamination or sharp cracks and test for any unexpected movement under load; replace if integrity is compromised.

What upgrades pair well with this upright?

Low-friction bearings, adjustable turnbuckles and fine-tuned front springs complement a graphite upright and help exploit its improved rigidity.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved