NT1 Centre Keyed Aluminium Monoblock Engine Mount - XRAY 338714  [XR-338714]

XRAY 338714 Aluminium Monoblock Engine Mount
Price:
£49.48
Brand:
XRAY
Model:
XR-338714
Condition:
Brand New
Write a review
alt="XRAY 338714 Aluminium Monoblock Engine Mount" title="XRAY 338714 Aluminium Monoblock Engine Mount"

Aluminium monoblock centre support assembly

The XRAY 338714 Aluminium Monoblock Engine Mount is manufactured as a single-piece, centre-mounted engine support compatible with NT1 on-road RC chassis. The monoblock body increases longitudinal stiffness in the centre section, while outer contact zones are machined away so lateral chassis flex remains available. This achieves stronger engine support without undermining handling or traction.

The keyed centre mounting secures accurate engine alignment and enables removal or replacement without upsetting the pinion-to-spur gear mesh, so you will not need to reconfigure gear spacing after service. Central attachment delivers structural support exactly where it matters for impact resistance and consistent alignment during setup work.

  • One-piece monoblock construction to add longitudinal rigidity at the chassis centre.
  • Centre-keyed design for precise engine positioning and fast swaps.
  • Machined clearances at outer sections to retain lateral flex characteristics.
  • No requirement to re-adjust gear mesh after engine removal or installation.

Specifications

  • Item: Aluminium Monoblock Engine Mount
  • Material: Swiss 7075 T6 aluminum, black anodized
  • Model Number: 338714
  • Compatibility: NT1, NT1.3 (330016)

Compatibility

  • NT1
  • NT1.3 (330016)

Offered as a direct-fit RC accessory for NT1 racers, this mount provides a rigid, keyed centre solution that simplifies engine maintenance while preserving intended chassis flex and reliable gear mesh alignment.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Does this replace the stock NT1 mount directly?

Yes. It is supplied as a direct-fit accessory for NT1 models and is compatible with NT1.3 (330016) as indicated in the specifications.

Are any shim or spacer changes needed on install?

Typically no. The keyed centre mount is designed to retain correct engine placement so additional shims for gear mesh are not normally required unless you are changing other drivetrain components.

How should I check alignment after fitting?

Verify the engine is seated into the key and that the pinion meshes cleanly with the spur under static rotation. Run a quick visual and feel check to confirm no binding before final assembly.

Will this change handling demands of the NT1?

The centre stiffening effect can alter longitudinal response slightly. Most drivers will find handling remains predictable, but small setup changes may be used to fine tune balance if required.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved