V One RRR Handle Bar V3R-028 Compatible with Kyosho by 3Racing  [V3R-028]

Handle Bar Replacement for V One RRR

This handle bar is supplied as a direct replacement for the Kyosho V One RRR and V One RRR Evo steering assemblies, intended to restore correct tie-rod geometry and predictable steering without altering the chassis layout.

Intended role and fitment: the part fits where the original steering link or handle bar is located, maintaining tie-rod alignment and steering response for on-road chassis. Treat it as a maintenance or tuning item rather than a stand-alone power upgrade.

Fitting instructions: remove the OEM handle bar, check link lengths and pivot alignment, install the replacement and confirm full, free movement through the steering travel. Inspect for binding and adjust toe and steering centring after installation. Reuse original mounting points and fasteners where appropriate and inspect link ball seats and bearings during the swap.

Tuning guidance: after replacement, re-check front-end geometry and steering throw. Minor changes to link lengths or pickup points will affect turn-in and mid-corner balance, so test on a short run and refine settings incrementally.