O.S. Engine OS44982200 Carburettor Rotor 61P FSa-110-P for O.S. Carburettor Parts  [OS44982200]

O.S. ENGINES CARBURETTOR ROTOR 61P FSa-110-P
Price:
£12.32
Brand:
O.S. Engine
Model:
OS44982200
GTIN:
4531028144910
Condition:
Brand New
Write a review

Replacement Rotor for O.S. Carburettor Parts

The O.S. Engine OS44982200 rotor is supplied as a direct replacement for original O.S. carburettor assemblies and is intended to restore proper rotor function when wear or damage affects fuel metering. The component is marked OS44982200 and carries the internal designation 61P FSa-110-P.

Fitting requires standard carburettor service practice: remove the carburettor, disassemble in accordance with the manufacturer's instructions, swap the rotor while aligning indexing marks and orientation, then reassemble and bench-test for unhindered movement before refitting to the model. Conduct a brief running check to ensure idle and throttle response are as expected.

This rotor is a maintenance item that helps maintain consistent fuel metering rather than a tuning device. After replacement, confirm needle valve and idle settings and perform measured running tests to verify the engine behaves predictably. Intended for model RC use only.

Specifications

  • Item: Carburettor rotor
  • Material: Not specified
  • Model Number: OS44982200
  • Compatibility: O.S. carburettor parts

Install this rotor during O.S. carburettor servicing to recover consistent throttle control and always test fit and function after installation.

Which O.S. carburettor models accept the OS44982200 rotor?

Compatibility depends on the specific O.S. carburettor design; refer to the carburettor service manual or parts diagram to confirm this model code fits your assembly.

How can I verify correct indexing and orientation?

Check for factory indexing marks and match rotor features to the carburettor body during assembly; alignment is important for predictable metering.

Is the OS44982200 identical to other O.S. part numbers?

Part numbers differ by design and application; do not assume interchangeability without checking part references and dimensions.

Can I confirm fit before full installation?

Dry-fit the rotor inside the carburettor body and verify smooth rotation and correct indexing before completing reassembly and final testing.

Are there visual checks to ensure part authenticity?

Inspect markings for the OS44982200 code and the internal 61P FSa-110-P reference; confirm machining and fitment quality as part of your inspection.

What should I do if the rotor does not fit correctly?

If fit is incorrect, do not force the part; verify part numbers and consult the carburettor diagrams or supplier to obtain the correct replacement.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved