Performance Carbon Rear Roller Plate M4WD-44/WO for Mini 4WD by 3Racing  [M4WD-44/WO]

Tamiya Mini 4WD Carbon Rear Multi Roller Plate Base TZ - 3RACING M4WD-44/WO
Price:
£2.30
Brand:
3Racing
Model:
M4WD-44/WO
Condition:
Brand New
Write a review

Performance rear plate M4WD-44/WO highlights

The M4WD-44/WO carbon rear multi roller plate is an aftermarket spare aimed at Mini 4WD racers and collectors who want a stiffer, lighter rear stay option. The description addresses fitment, material characteristics, and practical installation points for experienced hobbyists.

The construction uses a thin carbon fibre sheet as the main structural element, delivering increased rigidity with modest weight saving; this section explains implications for durability and mounting. Fitment is compatible with the typical Tamiya Mini 4WD rear stay patterns found on Super-II and MA chassis, but confirm the hole pattern against your own rear stay before final assembly.

Surface finish and edge treatment may vary by supplier; expect visible fibre texture and standard drilled holes for rollers and mounting posts. This item is sold as a spare accessory, not a kit part, and it integrates with common rear roller setups without altering chassis layout or drivetrain type.

Which Mini 4WD chassis use this plate

Designed for standard Tamiya Mini 4WD rear stays, especially those on Super-II and MA chassis; always measure hole centres to ensure a correct match.

What should I expect from carbon edges and finish

Carbon plates typically show fibre grain and may have clean or slightly rough edges depending on cutting method; inspect for burrs and smooth as needed.

Does this include rollers or screws

This sale is for the carbon plate only; check your vendor listing for any additional hardware and source standard Mini 4WD rollers or screws separately.

Any installation tips to avoid damage

Use washers, hand-tighten screws to a measured torque, and avoid overtightening through carbon to reduce risk of cracking or delamination.

Will the plate affect handling or weight

You may notice a firmer rear feel and slight weight change depending on plate thickness and choice of hardware, but results depend on the full setup.

Is this suitable for display and racing cars

Yes, it is suitable for both display models and race builds; as a spare accessory it keeps original chassis geometry while improving rear stay appearance.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved