Precision 24T Pinion Gear Compatible with RC Drivetrains - Yokomo YOKRP-036-24  [YOKRP-036-24]

Accurate pinion for ratio tuning and fitment

The Yokomo YOKRP-036-24 Precision Pinion Gear 24T is intended as a direct replacement or spare for electric drivetrain builds that accept a 24-tooth pinion. It is specified as a precision part to change final drive ratios while offering consistent meshing with matching spur gears during setup and tuning.

Installation follows common practice: loosen the motor pinion set screw, fit the 24T pinion to achieve the correct mesh with the spur gear, then secure the set screw and check for correct backlash and minimal runout. Always test engagement at low speed before normal operation and re-check fastenings after the first session.

In tuning scenarios, switching to this 24T pinion shifts the trade-off between acceleration and top speed in measured steps when paired with spur gear changes. Keeping bearings and spur gear surfaces in sound condition will help deliver the expected performance and reduce uneven wear.