Yokomo R12 Rear Body Mount Block Compatible with GT-Series - R12-22  [R12-22]

Yokomo R12-22 Aluminum rear body mount block for R12
Price:
£5.63
Brand:
Yokomo
Model:
R12-22
GTIN:
3888
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - R12 category
Write a review

Precision rear body mount for R12

This precision aluminium rear body mount block is produced for the Yokomo R12 platform and acts as a direct accessory for 1/12 touring RC models. It secures the rear shell while allowing measured adjustments to the body mounting point for consistent setup outcomes.

Compatibility relies on the chassis listing supplied with the item. It functions as a replacement on Yokomo R12 and can be fitted to specified GT-series chassis if mount geometry aligns. Always check hole spacing and mount alignment prior to fitting the part.

  • Supported chassis: GT5-R2 / GT5-RS2 / YR-R12C3 / YR-R12C31 / GT5-R35 / GT5-SC430 / GT3-REA / GT3-IS350 / GT3-B4 / GT3-CAX / GT3-BRZ / GT3-AHP / GT-B

Fitting advice: remove the rear body shell and existing hardware, trial-fit the block to confirm correct position, then tighten the mounting screws evenly. Use the appropriate hex driver and avoid over-torquing to protect threads and preserve alignment.

Performance note: the block offers a stable, repeatable datum for rear body position, which is useful when comparing different shells or making precise adjustments to rear body height during setup.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Which R12 variants will accept this block?

It is designed for the Yokomo R12 and listed GT-series models; verify your chassis variant against the supplied compatibility list to ensure the mount points match.

Does the block require different hardware to the stock part?

Typically it uses the stock mounting screws and body posts. During a test-fit, confirm screw length and thread pitch and only replace hardware if necessary for a secure fit.

Can this be used to standardise body height between shells?

Yes. The block provides a consistent mounting reference that makes it easier to set and compare body heights across different shells for tuning purposes.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved