RADTEC RAD-AC-10019 3x5.5x2.0mm Red Aluminium Spacer Set 10 Pack  [RAD-AC-10019]

RAD-AC-10019 3x5.5x2.0mm Aluminum Spacer, 10 pcs, Red
Price:
£5.23
Brand:
RADTEC
Model:
RAD-AC-10019
Condition:
Brand New
Write a review

Essential Aluminium Spacers for Accurate RC Setup

The RADTEC RAD-AC-10019 spacer pack contains ten 3x5.5x2.0mm red aluminium pieces for precise spacing tasks. Lightweight yet sturdy, these spacers let you make repeatable adjustments without adding unnecessary mass to the chassis. The anodised finish helps resist corrosion and makes parts easier to spot during servicing.

Applications and Fit

Suitable for fine wheel spacing, small suspension tweaks and other close-tolerance adjustments, these spacers work with a range of common hobby fastenings. Verify shaft and bolt sizes before fitting to ensure a snug, correct fit.

Service and Upkeep

These aluminium spacers are simple to inspect and clean, and the red coating aids quick identification when stripping or rebuilding components. Keep spare pieces on hand for setup trials or when changing component geometry.

Can these spacers be used on vintage kits with non-standard hardware?

They may work if the bore and thickness match your vintage hardware, but older kits sometimes require bespoke parts so double check measurements first.

Is anodised aluminium safe near electronics and wiring?

Yes, anodised aluminium is electrically conductive but is typically used away from sensitive wiring; ensure spacers do not short circuits and use insulating washers if needed.

Can I colour-code adjustments using different spacer sets?

The red finish makes these spacers easy to identify, and using different coloured spacers across setups is a good way to track changes between runs.

What is the best way to check spacer thickness during setup?

Use a set of feeler gauges or a digital caliper for accurate measurement, ensuring each spacer matches the intended stack or single use thickness.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved