RADTEC RAD-AC-10027 3x7x2.0mm Damper Spacer Set 8 pcs Orange  [RAD-AC-10027]

RAD-AC-10027 3x7x2.0mm Aluminum Damper Spacer, 8 pcs, Orange
Price:
£5.26
Brand:
RADTEC
Model:
RAD-AC-10027
Condition:
Brand New
Write a review

Accurate Suspension Shims from RADTEC

The RADTEC RAD-AC-10027 3x7x2.0mm aluminium damper spacer set provides a simple way to tune suspension geometry in measured steps. These lightweight spacers in orange are handy for iterating setup changes during test runs.

Tuning Benefits for Different Driving Styles

Use these spacers to refine front to rear balance, reduce understeer or tweak rebound onset on 1/10 scale cars. Small adjustments can translate into noticeable changes in corner entry and mid-corner stability.

Installation and Compatibility Tips

These spacers are compatible with many standard 1/10 scale dampers; fit them between the damper cap and the mounting eye to alter clearance. After installation, cycle the suspension to ensure free travel and correct seating.

Are these spacers suitable for both front and rear shocks?

Yes, the RAD-AC-10027 spacers can be used on front or rear dampers as long as the damper cap and mounting surfaces accept the 3x7x2.0mm dimensions.

Should I change shock oil after fitting spacers?

Not immediately; spacers mainly change geometry. If the handling change suggests different damping, then consider adjusting oil weight or spring rate as a follow-up.

How do I verify correct fitment?

After fitting, check that the spacer sits flush, that the damper shaft moves freely through full travel and that there is no binding at the mounting points.

Can these spacers be used with aluminium shock towers?

Yes, they work with aluminium towers; just ensure clearances remain correct and that the stack height does not interfere with suspension travel.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved