Radtec RAD-BEL-10005 Low Friction Front Drive Belt S3M351 for A800 Stock  [RAD-BEL-10005]

RAD-BEL-10005 Radtec Low Friction White Front Drive Belt (S3M351) for Stock (A800)
Price:
£12.30
Brand:
RADTEC
Model:
RAD-BEL-10005
Condition:
Brand New
Write a review

Refine A800 Stock Drive with the Radtec RAD-BEL-10005

The Radtec low friction white front drive belt S3M351 is intended for the A800 Stock to lower mechanical resistance and promote more consistent power transfer. It aims to help field setups maintain cleaner drive feel during laps.

What the Radtec Belt Brings to Your A800

Produced to match S3M351 belt profile requirements, the Radtec unit reduces contact friction and helps reduce speed losses across the pulley system. The white colour makes damage and contamination easier to spot during checks.

Fitment Advice and Care Routine

Prior to installing the Radtec RAD-BEL-10005, verify pulleys and shafts are free of grit and bearing play is minimal. Apply correct alignment and moderate tension, then re-check after a short run to ensure the belt has seated. Swap the belt if you spot tooth wear or fraying.

Is this belt suited to high grip tracks?

Yes, the Radtec RAD-BEL-10005 can be used on high grip surfaces but correct tensioning is essential to avoid excess load on bearings. Regularly monitor wear if running on abrasive tracks.

Can I use the belt with aftermarket clutches or pulleys?

The belt will work with aftermarket parts that maintain the S3M351 tooth profile and correct width. Confirm pulley alignment and tooth pitch before fitting to avoid premature wear.

How should I store spare belts?

Store belts flat in a cool dry place away from direct sunlight and solvents. Avoid bending them sharply and keep them clean to preserve elasticity and tooth integrity.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved