RAD-YK-10018 RADTEC BD8-2017 Aluminium 0 Degree C-Hub  [RAD-YK-10018]

RAD-YK-10018 BD8-2017 Aluminum C-Hub for RTC, 0 Deg
Price:
£22.50
Brand:
RADTEC
Model:
RAD-YK-10018
Condition:
Brand New
Write a review

Upgrade for Consistent Steering

The RADTEC RAD-YK-10018 aluminium C-Hub is an effective upgrade for Yokomo BD8-2017 owners aiming for steadier steering feedback. The 0 degree profile helps preserve neutral camber during typical driving loads.

Precision Machining and Longevity

Crafted from aluminium to close tolerances, this C-Hub offers a more rigid mounting point than injection moulded alternatives. That precision reduces unwanted movement and gives repeatable steering input.

Compatibility Notes and Fit

Specifically produced for the BD8-2017 platform, the C-Hub aligns with factory holes and hardware for a straightforward replacement. Installation uses your existing components and requires minimal setup time.

Can this hub be used with standard BD8-2017 ball joints?

Yes, it is compatible with the standard ball joints and uses the same mounting points as the original hubs.

Does the 0 degree option improve straight-line stability?

Keeping camber neutral with a 0 degree hub can aid straight-line stability, making the car less twitchy under acceleration and at high speed.

How should I check fitment after installation?

After fitting, cycle the suspension through its travel to confirm there is no binding, then verify wheel alignment and retighten mounting screws to spec.

Is there any maintenance specific to aluminium hubs?

Inspect for nicks or deformation after heavy impacts, keep mounting surfaces clean, and apply threadlocker where recommended to prevent fastener loosening.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved