Rear Hub Carrier for Yokomo B-Max-2 - YOKB2-415R  [YOKB2-415R]

Fitment and replacement guidance for the B-Max-2 rear hub

The Yokomo YOKB2-415R functions as a direct replacement rear hub carrier for the B-Max-2 1/10 touring chassis. It provides the structural interface between the wheel hub assembly and the rear suspension upright, maintaining chassis geometry when properly fitted.

Fit and installation: this carrier is intended to replace the OEM rear hub carrier on a B-Max-2 without modifying neighbouring assemblies. When installing, ensure the part aligns precisely with the rear upright and that all mounting holes and fixings correspond to the chassis locations; employ correct hex drivers and follow safe RC workshop practice. Avoid overtightening and inspect thread condition before final torqueing.

Adjustment impact: replacing the carrier is a common service task to recover factory geometry or to explore alternate mounting offsets where available. Changes at the hub carrier influence camber and toe behaviors, so check handling on short runs and refine settings as needed after replacement.

Servicing tips: during routine maintenance inspect the carrier for deformation, check bearings and wheel hexes for excessive play, and replace any worn fasteners. Clean mating surfaces and ensure debris is removed prior to reassembly to secure repeatable alignment.