Reverse Pusher APC AP11045MRP 11x4.5MR Propeller for RC Electric Multirotors  [AP11045MRP]

11x4.5MR Reverse Pusher Prop for RC Electric Multirotors

This APC AP11045MRP propeller is supplied as a replacement blade for RC electric multirotor platforms requiring reverse or pusher mounting. The 11x4.5MR label describes the diameter and pitch that help determine suitability for your motor and frame.

When installing, orient the blade to match motor rotation and the mount's intended role, noting whether a front-pulling or rear-pushing face is needed. Make sure the prop is fully seated on the motor shaft and that fasteners are secure, then perform a low-throttle bench test to check rotation and clearance before flight.

Check blades for any damage before initial use and consider static balancing to reduce vibration transmitted to the motors and ESC. Remember that fitting reverse or pusher props can change thrust direction and trim; adjust controller trims or motor timing where necessary to restore a neutral hover and efficient power use.