Reverse/Pusher Propeller APC AP11080EP 11x8EP Electric  [AP11080EP]

APC PROPELLER 11x8EP ELECTRIC REVERSE/PUSHER
Price:
£3.60
Brand:
APC
Model:
AP11080EP
Condition:
Brand New
Write a review

Compatibility and propeller tuning essentials

The APC AP11080EP is an 11x8EP electric prop engineered for reverse and pusher installations on RC models. Its geometry produces effective thrust at cruising RPMs, with a design focus on predictable performance rather than low-end torque.

Installation notes: confirm shaft size and adapter fit before mounting, tighten the nut to the adapter supplier's specification, and check that prop orientation results in thrust in the intended direction. Perform a motor and ESC rotation check before the maiden run.

Tuning guidance: pitch and diameter determine static thrust and attainable RPM. Pair this 11x8 prop with motors and ESCs that run efficiently at higher RPM ranges. Keep the prop balanced and inspect blades for chips to avoid vibration and inconsistent loading.

Safety and maintenance: always balance the prop before use, replace any chip-damaged blades, and keep a safe exclusion zone during engine run-up. Use correct locking hardware and thread locking compounds when appropriate for your hub system.

Will this prop affect motor temperature significantly?

If the motor is undersized for the higher RPM demand of an 11x8, temperatures can rise; verify current draw on the ground and ensure adequate cooling or choose a motor with appropriate continuous amp capacity.

Can I repair minor blade nicks?

Small cosmetic nicks may be smoothed, but any structural damage that changes balance or compromises the blade should prompt replacement to avoid vibration and failure.

How should I test the prop before flight?

Mount the prop securely, perform a ground run to check rotation and current draw at typical throttle, and confirm there is no undue vibration before flight.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved