ROCHE Rapide P10 WGTR Motor Mount and Rear Bulkhead C10248  [RH-210241]

RH-210241 Rapide P10 WGTR Aluminum Motor Mount / Rear Bulkhead C10248
Price:
£13.52
Brand:
ROCHE
Model:
RH-210241
Condition:
Brand New
Write a review

ROCHE Aluminium Motor Mount Built for Rapide P10 WGTR

Enthusiasts upgrading their Rapide P10 WGTR will find the ROCHE RH-210241 aluminium motor mount and rear bulkhead a practical replacement for the original. The aluminium construction boosts structural strength and assists in shedding heat from the motor area.

Why Choose a Metal Mount

Metal mounts reduce unwanted flex compared to softer materials, improving throttle feedback and keeping motor alignment stable under load. Aluminium gives a balance of strength and manageable weight.

Compatibility with Rapide P10 WGTR

The RH-210241 is designed around Rapide P10 WGTR mounting points so you should get a correct fit with standard hardware. Follow routine checks for motor spacing and pinion engagement when fitting.

Recommended Use and Benefits

This mount is beneficial for racers and weekend drivers looking for more consistent motor performance over extended runs or during competitive events.

Will fitting ROCHE C10248 change handling?

It can lead to a firmer feel due to reduced flex, which often improves steering precision; fine tuning of suspension settings may be needed to match the new behaviour.

Is this mount compatible with the stock gearbox?

Yes, it is intended to work with the stock Rapide P10 WGTR gearbox layout, though you should check gear mesh and motor offset after installation.

Do I need to re-tune ESC settings?

No major ESC changes are usually needed, but monitor motor temperature and performance on a test run and adjust timing or power settings if you notice higher loads.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved