ROCHE 320148 Rapide F1 EVO Graphite Front Arm Mount Plate (A) 3/6 Degree S20182 - Race Trim Plate  [RH-320148]

ROCHE 320148 Rapide F1 EVO Graphite Front Arm Mount Plate (A), (3/6 deg) S20182
Price:
£4.49
Brand:
ROCHE
Model:
RH-320148
Condition:
Brand New
Write a review

Optimise Your Rapide F1 EVO Steering Geometry

The ROCHE 320148 Rapide F1 EVO Graphite Front Arm Mount Plate (A) lets racers refine front geometry to suit driving style and circuit layout. Choose between 3 and 6 degree settings to adjust how the car turns and tracks.

Advantages of Using Graphite

Graphite offers a favourable trade-off between lightness and structural integrity, helping to reduce unnecessary mass while keeping key areas stiff. This supports quicker steering inputs and consistent handling under load.

How It Fits and What to Expect

Fitting the plate to the Rapide F1 EVO is straightforward and intended for racers who need quick, repeatable setup changes. After installation, verify alignment and tighten fasteners to the recommended spec to ensure reliable performance.

Does the plate require special fasteners?

The plate uses standard mounting hardware supplied with the Rapide F1 EVO or common RC fasteners; check thread sizes and torque to avoid loosening under load.

Should I change camber or toe after adjusting angle?

Angle changes can alter contact patch behaviour, so it is a good idea to recheck camber and toe settings after adjustment to maintain balanced tyre wear and handling.

Is this mainly for track or street use?

The plate is aimed at track and club racing where fine geometry adjustments matter, though hobbyists running smooth street circuits can benefit from the tuning options as well.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved