ROCHE 320170 Rapide F1 EVO Graphite Front Arm Set (+2mm) - Circuit Performance Upgrade  [RH-320170]

ROCHE 320170 Rapide F1 EVO Graphite Front Arm Set (+2mm)
Price:
£18.82
Brand:
ROCHE
Model:
RH-320170
Condition:
Brand New
Write a review

Precise Handling Upgrades for Rapide F1 EVO

The ROCHE 320170 Rapide F1 EVO Graphite Front Arm Set provides a practical handling improvement for serious hobbyists. Increasing the wheelbase by 2mm helps the car track truer through fast sections and long corners.

Engineered Graphite Components

Produced from engineered graphite, these arms aim to reduce flex without adding excess weight, helping to maintain consistent steering response lap after lap. The material choice supports repeatable setup changes.

Fitment and Setup Advice

Specifically made for the ROCHE Rapide F1 EVO chassis, the arms install using the stock mounting points for a direct replacement. After fitting, check steering geometry and perform a few short runs to fine tune handling.

Does this alter the wheelbase length?

Yes, the front arm set adds 2mm to the wheelbase, which typically improves stability and reduces nervous steering at speed.

Will older Rapide kits accept these arms?

These parts are intended for the Rapide F1 EVO platform. Older or different Rapide variants may have different mounting points, so confirm dimensions before attempting to fit them.

What tools are recommended for installation?

Typical RC hand tools such as hex drivers and a small torque driver are sufficient. After installation, check alignment and secure fasteners to the recommended torque to avoid loosening on track.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved