SAK-D6814/PU Purple Aluminum KPI Knuckle for Auper D6 by 3Racing  [SAK-D6814/PU]

Aluminum KPI knuckle built for Auper D6 applications

This aluminum KPI knuckle is manufactured for the Auper D6 platform as a practical steering component for modellers requiring a reliable replacement or a material-matching upgrade. The knuckle keeps the KPI mounting layout found on Auper D6 chassis and carries a purple anodized finish for visual distinction.

Employ the part when adjusting static KPI and steering link geometry during setup changes. It interfaces with standard Auper D6 steering arms and matches the stock axle and kingpin positions, so installation follows the chassis' established steering assembly routine. Inspect bearings and verify fastener torque after fitting to ensure correct alignment.

Material and surface finish are listed to communicate expected handling and wear in typical RC running; this is an accessory intended strictly for model platforms.

Installation is uncomplicated for those experienced with Auper D6 steering geometry; use standard steering hardware and check clearances during assembly.