SAK-F84 3Racing 17T POM Idler Gear for SAKURA FF EVO Performance Fit  [SAK-F84]

SAKURA FF EVO POM Moulded Idler Gear 17T For KIT-FFEVO - 3Racing SAK-F84
Price:
£3.74
Brand:
3Racing
Model:
SAK-F84
Condition:
Brand New
Write a review

POM idler part for SAKURA FF EVO

The 3Racing SAK-F84 17T POM idler is produced to match the KIT-FFEVO drivetrain, using POM for consistent, low-friction operation. It supports steady torque transfer and reduces noisy meshing under varied running conditions.

Wear resistant 17-tooth profile

Its 17-tooth design delivers a balance of strength and smooth rotation. POM, or polyoxymethylene, gives good sliding properties and resists abrasion, extending service intervals versus lower-grade plastics.

Direct fitment to FFEVO chassis

Configured for the FFEVO mount geometry, the SAK-F84 drops into the standard idler position with minimal adjustment. It is suitable as a maintenance part or a simple upgrade for racers seeking consistent gear behaviour.

Does this require shims to fit?

Most FFEVO builds accept the SAK-F84 without extra shims, but minor spacing adjustments may be needed on modified or older chassis variants.

How should I check for wear?

Examine teeth for rounding, chips or flat spots after extended use. Also check for shaft play and confirm the idler runs true under load.

Can I use this on a tuned gearbox?

Yes, the SAK-F84 suits tuned FFEVO drivetrains. Ensure correct mesh and alignment, and consider a light plastic-safe lubricant for high rpm or prolonged runs.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved