SAVAGE XS FLUX Rear Lower Arm 7075-T6 DT4056 Aftermarket Option by GPM  [DT4056]

Rear lower suspension arm compatible with SAVAGE XS FLUX

This replacement rear lower suspension arm is precision-machined from 7075-T6 aluminium alloy as an aftermarket component for the rear lower suspension area on compatible models. The arm is anodized in sky blue, black, or silver and supplied with the necessary pins and screws for a straightforward installation. Hardware is pre-assembled where applicable, and medium-strength screw glue is recommended to help prevent loosening during operation.

The alloy construction delivers a balance of increased strength and reduced mass compared to standard plastic arms, helping the suspension keep correct geometry under heavier loads or rough surfaces without implying any real vehicle use. Fit this arm to restore damaged factory items, preserve pivot geometry, or trial changes to suspension behaviour as part of tuning. After fitting, double-check symmetry and clearance as handling can be affected.

Fitting instructions: remove the original rear lower suspension arm and transfer any bearings or inserts as required, align the replacement arm with the mounting points, fasten with the supplied stainless steel pins and Grade 12.9 black round head screws, and apply medium-strength screw glue on threaded fixings where advised. Confirm free suspension travel before first use.

This arm is supplied as a direct aftermarket rear lower suspension replacement for the listed models, offering a durable aluminium choice for routine repairs and incremental tuning adjustments.