Schumacher FT9 Rear Right Graphite Hub Plate Compatible Upgrade - Factory Pro O-SCP038R  [FP-O-SCP038R]

Price:
£6.51
Brand:
Factory Pro
Model:
FP-O-SCP038R
Condition:
Brand New
Write a review

Right rear steering hub plate for FT9

The Factory Pro O-SCP038R steering hub plate is an aftermarket RC-scale replacement developed for the Schumacher FT9 chassis, intended for the rear-right steering or upright location. It is produced in graphite as indicated by the product name and is meant to fit the FT9 steering assembly without altering the chassis geometry.

Fit and installation notes: confirm correct alignment with the FT9 upright and bearing bores before finishing the installation, reuse original screws and pins where applicable, and verify wheel toe and steering travel once fitted. The item is supplied as 1 pcs and intended to swap in for the FT9 stock right rear steering hub plate.

Tuning role: replacing a plastic hub with graphite changes local stiffness and can affect steering accuracy and feedback at the rear axle. Use this part when making careful adjustments to rear steering stiffness or replacing a damaged FT9 hub plate.

Will this fit non FT9 uprights?

The hub plate is designed for the FT9 and other uprights may not match the mounting points. Measure bore spacing and boss layout before trying to install on a different model.

How does this affect handling?

A graphite hub increases local stiffness, which can sharpen steering response and change rear-end feedback. Small incremental tests are recommended to evaluate the effect on handling.

Do I need special tools to fit it?

No special tools are required beyond standard RC hand tools. Fit the hub loosely, check alignment and steering geometry, then torque evenly to avoid binding.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved