Schumacher FT9 Steering Hub Plate RL Graphite Replacement - Factory Pro O-SCP038L  [FP-O-SCP038L]

Price:
£6.51
Brand:
Factory Pro
Model:
FP-O-SCP038L
Condition:
Brand New
Write a review

Replacement steering hub plate for FT9

This Factory Pro aftermarket steering hub plate is an RC-scale replacement made for the Schumacher FT9 platform, supplied as 1 pcs and fabricated from graphite. It is intended to be a direct-fit hub plate within the FT9 steering assembly, using graphite for its stiffness and predictable wear characteristics in scale touring car applications.

Installation notes: confirm correct orientation with your existing hub and FT9 chassis references, employ standard RC hex drivers for removal and refit, and inspect mating surfaces and bearings before final assembly. Retain original mounting hardware if compatible and apply your normal torque settings to hub fastenings.

Tuning role: this plate acts as a structural mounting point for steering geometry; after fitting a graphite plate pay attention to steering feedback and any linkage alignment shifts, then re-check toe and caster. Periodic checks of contact faces and 走珠軸承 will help maintain consistent steering behaviour during running.

Will this improve front end precision?

Graphite can increase stiffness which may sharpen steering feel, but tuning and alignment adjustments are usually required to notice handling differences.

Do I need special bolts or washers?

Use the original mounting hardware where it fits correctly. If bolts or washers show wear, replace them with equivalent RC-grade hardware to ensure secure mounting.

How do I spot wear on this plate?

Inspect the contact faces and 走珠軸承 for flattening, cracking or play. Any abnormal wear should prompt bearing replacement and a check of mating components to avoid further damage.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved