Schumacher Neon 210mm Graphite Chassis Plate 2.25 Factory Pro O-SMCP01  [FP-O-SMCP01]

Price:
£33.95
Brand:
Factory Pro
Model:
FP-O-SMCP01
Condition:
Brand New
Write a review

Primary Details for Neon 210mm Main Chassis

This Factory Pro main chassis is produced for the Schumacher Neon and matches the 210mm wheelbase configuration. It is intended as a direct replacement or as a neutral platform for setup adjustments while keeping the Neon mounting pattern intact.

The 2.25mm graphite thickness in the model name is the key structural feature to factor into tuning decisions. When swapping plates, reuse the original fixings and confirm motor mount, gearbox, and suspension pick-up positions to avoid unwanted changes to geometry.

Fitment checklist for preparatory work: inspect fastener threads, transfer any run-specific shims or spacers to the new plate, and double check battery and electronics clearance prior to finishing the build. The chassis provides a stable reference for setup tuning rather than an immediate performance upgrade.

Specifications

  • Item: Main chassis (Schumacher Neon)
  • Material: Graphite 2.25
  • Model Number: Factory Pro O-SMCP01
  • Compatibility: Schumacher Neon, wheelbase 210mm

Opt for this chassis when you need a reliable graphite main plate or a repeatable baseline for setup work; always confirm the fit with your existing Neon components before final assembly.

Can I expect perfect hole alignment out of the box?

The plate is manufactured to the Neon 210mm pattern, but it is good practice to check all holes and transfer any shims from the original plate during the initial dry fit.

What torque approach is recommended for graphite?

Use a measured, light torque and avoid overtightening into the graphite; metal-to-metal joints may benefit from a small amount of threadlocker if required.

Will switching to this chassis require spring or damper changes?

Graphite flex can alter handling subtly, so expect to fine tune springs and dampers to restore your preferred balance after fitting the new plate.

Is additional reinforcement needed around mounting holes?

Generally not for standard use, though using washers under metal screws can help spread the load and protect the graphite in high-stress mounting points.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved