Schumacher Neon 210mm Wheelbase Graphite Kit by Factory Pro O-SMCK01  [FP-O-SMCK01]

Price:
£45.26
Brand:
Factory Pro
Model:
FP-O-SMCK01
Condition:
Brand New
Write a review

210mm conversion option for Schumacher Neon

This graphite conversion kit is an accessory designed to convert the Schumacher Neon chassis to a 210mm wheelbase. It is presented as a functional layout change for hobby drivers concentrating on setup and handling rather than visual modifications.

Adjusting wheelbase changes weight distribution and alters entry and mid-corner behaviour. Anticipate setup work to restore balance: reposition shock mounting, check roll centre, and fine tune toe and ride height. These parts are intended for direct use on Schumacher Neon cars where a 210mm setup is sought for specific track tuning.

Specifications

  • Item: Wheelbase 210mm Conversion Kit
  • Material: Graphite
  • Model Number: O-SMCK01
  • Compatibility: Schumacher Neon

Apply this conversion when you need a consistent 210mm wheelbase on a Schumacher Neon chassis; pair the change with careful suspension and alignment checks to reach the targeted handling balance.

Do I need to change springs after converting the wheelbase?

Spring choice depends on how the car balances after conversion. Start with your usual springs and adjust rates if front or rear balance shifts noticeably during testing.

Will driveline angles be affected?

Yes, changes to wheelbase can alter driveline geometry. Inspect joint angles and ensure there is no binding; make small mounting adjustments if required.

Can I revert to the original wheelbase later?

Most conversions are reversible if you keep the original parts and fasteners. Label parts and keep a simple parts tray to make reverting straightforward.

How should I approach testing after the swap?

Run controlled test laps and change one setup variable at a time. Note handling differences and return to baseline settings between changes to track improvements accurately.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved