Serpent SER401878 Rear Stiffener Set for X20 - Rear Brace Kit  [SER401878]

Serpent SER401878 Rear stiffner set X20
Price:
£24.92
Brand:
Serpent
Model:
SER401878
Condition:
Brand New
Write a review

Rear Stiffener Solution for Medius X20

The Serpent SER401878 Rear Stiffener Set adds structural support to the rear section of the Medius X20 chassis, helping to limit flex under load. This upgrade improves rear predictability for 1/10 electric touring car drivers chasing cleaner corner exits.

Specifically for Medius X20 MID Cars

This stiffener is intended for Medius X20 MID 1/10 EP variants (SER400033 and SER400034) and mounts into the existing chassis layout. It is a practical option for those refining handling on club and regional circuits.

Mounting Advice and Care

Use the correct screw torque and verify tightness after initial running to prevent movement. Periodic checks of the bracket and screws will preserve consistent handling characteristics.

Does the stiffener affect tyre wear?

By changing chassis stiffness you may alter load transfer, which can influence rear tyre wear; monitor tyre edges and adjust camber or toe if needed.

What material is the stiffener made from?

This part is a purpose designed stiffener produced to match the Medius X20 mounting points and intended to provide durable reinforcement for race use.

Can I run the car without the stiffener for casual practice?

Yes, the car will run without it, but the stiffener helps with consistency at higher speeds and under heavier cornering loads, so it is recommended for competitive sessions.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved