Serpent 402180 Medius X26 Wishbone Insert Set (12 pcs)  [SER402180]

Front wishbone inserts for Medius X26

This RC-scale item is a direct-fit wishbone insert pack for the Serpent Medius X26 platform. It comprises 12 X26 inserts that locate inside the wishbone pocket to adjust the contact between arm and pivot, helping to refine suspension behaviour without the need to replace the whole wishbone.

Service and role: inserts are used to reduce slop, slightly alter leverage characteristics and offer a simple, serviceable method to tune compliance during setup cycles. They are suitable for 1/10 electric touring car suspension tuning where measured, small changes are preferred.

How to fit: remove the wishbone from the chassis, clean the pocket and remove any burrs, press the X26 insert into the cavity until it is seated, reassemble and verify full, unobstructed travel. Check steering clearance and suspension movement before running. No specialist tooling is required; handle steel parts using normal workshop precautions.

Compatibility note: intended for use with the Serpent Medius X26 chassis family and compatible with Medius X26 steel EP components where wishbone insert tuning is supported.