Serpent 402196 Antiroll Bar 1.4mm for Medius X26 steel EP (SER400052)  [SER402196]

1.4mm Sway Bar for Precise Roll Control

The Serpent 402196 antiroll bar is an RC suspension component intended for the Medius X26 steel EP platform (SER400052). As a 1.4mm option it offers a reliable means to influence lateral stiffness and reduce body roll without altering springs or dampers.

Fitting is performed at the chassis level where the antiroll bar mounts to the Medius X26 linkage points. Verify that linkages pivot freely and that end links remain free of binding through full travel. Correct installation preserves consistent roll behaviour and the intended suspension geometry.

When tuning, a step up to a 1.4mm bar will typically increase roll resistance compared with thinner bars, concentrating effects on transient roll and corner entry balance. Introduce the change as part of staged setup adjustments and test on-track to dial in handling.

Steel antiroll bars require routine checks: inspect link pivots and the bar surface after heavy use, re-tighten mounting hardware to specified torque, and replace the bar if deformation or marked wear is detected.

Apply the Serpent 402196 antiroll bar to refine roll behaviour on Medius X26 steel EP cars, using measured suspension tweaks for consistent handling outcomes.