Serpent 440145 Mini Spyder SER440001 Steering Replacement  [SER440145]

Serpent SER440145 Servo Mini Spyder MT
Price:
£12.06
Brand:
Serpent
Model:
SER440145
Condition:
Brand New
Write a review

Mini Spyder replacement servo notes

The Serpent 440145 is presented as a spare steering servo for the Mini Spyder Monster truck RTR EP (SER440001) model. The content below explains fitment checks, connector and horn compatibility, and practical steps for safe installation.

Because the part refers to the Mini Spyder RTR platform, verify the servo's mounting pattern and connector match your vehicle before fitting. Consider the unit an accessory component and avoid exceeding typical hobby electrical specifications when testing and running the truck.

On swap-out, inspect spline counts, horn seating, and clearance inside the steering assembly. Complete neutral trimming, endpoint calibration, and a short test run to confirm steering geometry and to detect any mechanical interference.

Specifications

  • Item Servo Mini Spyder MT
  • Material Not specified
  • Model Number SER440145
  • Compatibility Mini Spyder Monster truck RTR EP (SER440001)

Use this spare on compatible Mini Spyder RTR builds and follow a standard verification routine—trim, endpoints, and horn alignment—to restore predictable steering behavior.

Does the servo use a standard connector for SER440001 models?

Connector type can vary between RTR builds. Confirm the plug on this replacement matches your receiver or use an appropriate adapter; never force mismatched plugs into sockets.

How do I confirm spline and horn compatibility?

Compare spline counts and check that the servo horn seats flush on the output spline. Swap to a matching horn if the supplied one does not align with your linkage hardware.

What precautions prevent damage during installation?

Power the servo only with the receiver on to set neutral, avoid forcing linkages, and verify endpoints before driving to prevent overtravel and gear stripping.

Where should I recycle old servos and electronics?

Dispose of radio gear via local electronic waste services. Remove any batteries and wiring, then hand the unit to an authorised e-waste collection facility for safe processing.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved