Serpent 500896 SRX 13mm Rod End +2 (4)  [SER500896]

13mm rod end +2 for SRX shock assemblies

The Serpent 500896 Shock 13mm rod end +2 is supplied as a set of four and fits SRX shock assemblies. These components give a +2 offset at the 13mm connection, enabling small geometry changes while keeping shock internals unchanged.

Fitment instructions: remove the existing end link or lower collar, replace it with the 13mm +2 rod end, and check that the joint moves freely through the full suspension travel. They are designed to work with standard RC shock ball studs and common link hardware; always verify thread fit and engagement before final torque.

Compatibility notes: while designed for SRX units, confirm ball stud size and thread engagement on your particular chassis to guarantee correct operation and avoid binding or poor engagement.

Store a spare set with your setup gear to trial small geometry steps and check articulation after each change.