Serpent Medius X26 Main Chassis Upgrade Graphite 2.25 O-SPP001 by Factory Pro  [FP-O-SPP001]

Price:
£34.02
Brand:
Factory Pro
Model:
FP-O-SPP001
Condition:
Brand New
Write a review

Main chassis replacement for Serpent Medius X26

This Factory Pro main chassis plate is made for the Serpent Medius X26 1/10-scale touring car and is supplied as a graphite 2.25mm centre plate. As an aftermarket component, it is intended to adjust chassis stiffness and therefore influence handling for different track conditions.

Fitment concentrates on direct replacement of the factory main plate on Medius X26 configurations. When preparing a swap, verify that existing standoffs and electronics clearances suit the graphite plate profile and that the Medius X26 mounting holes align correctly. The material choice and thickness alter flex characteristics so racers can tune understeer and oversteer without touching suspension geometry.

After fitting, perform routine checks for secure fasteners and inspect for any delamination or edge dinging. Graphite is lighter and stiffer than many composites, so expect to make small suspension or anti-roll bar changes to restore your preferred handling balance.

Specifications

  • Item: Main chassis
  • Material: Graphite 2.25
  • Model Number: O-SPP001
  • Compatibility: Serpent Medius X26

Compatibility

  • Serpent Medius X26

Choose this chassis plate to change the central rigidity on a Medius X26, then carry out measured suspension adjustments to evaluate the effect on consistent lap performance.

Will this plate match the Medius X26 factory hole pattern?

Yes, the plate is produced for the Medius X26 mounting pattern. Always double check that your standoffs and screws line up before tightening.

How should I check for edge damage after running?

Perform a visual inspection for chips or delamination along edges and mounting points after any heavy impact. Replace the plate if you find structural cracks.

Will I need different fasteners for this plate?

Often existing fasteners will work, but confirm their length and thread type suit the 2.25mm graphite plate. Replace hardware if it does not match the new thickness.

Does a thicker chassis affect electronics layout?

The increased thickness can slightly change stacking heights. Verify ESC, motor and servo clearance and adjust mounting if any interference is observed.

Is this suited to different track surfaces?

Yes. A stiffer plate tends to perform well on smoother circuits, while rougher surfaces may require different spring or damper settings to maintain grip.

Does the product listing include installation guidance?

The sale covers the main chassis plate only and assumes familiarity with Medius X26 assembly. Refer to your car manual or seek advice from experienced builders if needed.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved