Serpent Medius X26 Precision Bulkhead Brace - O-SPP004 by Factory Pro  [FP-O-SPP004]

Factory Pro supplies this graphite bulkhead brace for the Serpent Medius X26 as an aftermarket stiffening plate for RC touring cars. It is trimmed to mount on the Medius X26 bulkhead area to influence handling characteristics during corner entry and transitions.

The brace increases stiffness locally at the bulkhead connection, which alters the distribution of flex through the chassis. That makes it easier to fine-tune front and rear grip balance without changing suspension geometry. Consider it as a targeted tuning option when seeking more predictable handling.

Fitment follows normal Medius X26 service steps: remove the body where necessary, unbolt the existing bulkhead fasteners, place the graphite brace into position and secure with the original hex screws. After installation, double-check driveshaft and linkage clearances.

Note that compatibility is restricted to the Serpent Medius X26 chassis only; confirm your chassis code to avoid ordering the wrong part. This is a model-only component and not suitable for any full-size vehicle use.