Serpent Medius X26 Rear Body Mount Plate O-SPP010 Graphite by Factory Pro  [FP-O-SPP010]

Service replacement rear plate for Medius X26

This rear body plate is an aftermarket replacement manufactured by Factory Pro for use with the Serpent Medius X26 chassis. The part number is Factory Pro O-SPP010 and it is finished in graphite to suit the vehicle's rear body mount points.

The plate functions as a direct-replacement mount panel and can also be used as a modest tuning item where rear stiffness and small mass changes influence handling. It is designed for hobby use on the Medius X26 and must be installed at the original mounting locations with the car's factory hardware.

To install on a Medius X26: remove the existing plate, confirm alignment of mounting posts and holes, reuse the original screws or fixings, and check body clearance around the suspension and motor area. Once fitted, ensure the body sits correctly and nothing interferes with suspension travel or rear gearbox parts.

Service guidance: after impacts inspect the graphite plate for cracks, keep mounting faces clean, and retorque fasteners after the first run to secure seating. The part is intended to restore the correct rear body geometry following a crash or wear.