Serpent SER110101 Countersunk Screw m4x8 Pack of 10  [SER110101]

Serpent SER110101 Screw Allen Countersunk m4x8 (10)
Price:
£5.38
Brand:
Serpent
Model:
SER110101
Condition:
Brand New
Write a review

Low Profile Fixings for Model Builders

The Serpent SER110101 Countersunk Screw Set includes ten M4x8 fasteners intended to provide a recessed head when fitted. They are handy for assemblies where a flat surface is preferred.

When to Choose Countersunk Screws

Choose countersunk screws for exterior panels, body clips and areas where a protruding head would be undesirable. They help preserve clean lines and reduce snag points.

Compatibility Tips

These screws will work with a variety of RC components, but make sure the length and thread match the part you are attaching. Test on scrap material if you are unsure before final fitting.

Do I need a special driver for these screws?

An Allen key or hex driver that fits the head profile is recommended to avoid rounding the recess and to ensure proper torque during installation.

Will these fit standard RC chassis holes?

They will fit where the chassis accepts M4 diameter screws and where the hole depth supports an 8mm length. Check measurements against your parts first.

How do I remove a seized screw?

Apply penetrating oil and allow time to work, then use the correct Allen tool with controlled force. If needed, heat the area carefully to help loosen the joint.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved