Serpent 302040 - M3x78 Trackrod for F190 EP Competition Link  [SER302040]

Serpent SER302040 Trackrod M3x78
Price:
£5.88
Brand:
Serpent
Model:
SER302040
Condition:
Brand New
Write a review

Refine Steering on the F190 EP with Serpent 302040 - M3x78 Trackrod

Drivers aiming for consistent lap times will appreciate the Serpent M3x78 trackrod. Engineered for the F190 EP line, it tightens steering precision and is made to endure typical club and competition use. Its measured tolerances let you tune without compromising durability.

Fine Tuned Geometry for Stable Handling

The M3x78 trackrod is crafted to strike a balance between rigidity and controlled flex so steering inputs translate predictably. This aids setup work and helps stabilise entry and exit behaviour through corners.

Made to Mate with the F190 EP Chassis

Produced for use with the F190 EP (SER300030) chassis, the trackrod aligns with stock mounts for a straightforward fit. Its compatibility makes it a practical choice for repairs or as an upgrade during setup changes.

Can I adjust this for different steering ratios?

Adjusting link length and servo endpoints can alter steering ratio feel. Use measured increments and test on a short run to confirm the change suits your setup.

What maintenance should I perform?

Inspect the trackrod and ball ends for wear, clear debris after running, and ensure threads remain secure. Replace worn ends to retain precise steering.

Will it work with aftermarket steering systems?

It can be used with many aftermarket setups if thread and length match. Verify compatibility dimensions before installing with non OEM components.

Is any break in needed?

No special break in is required. After installation, check for smooth movement and recheck tightness after the first few runs.

How do I check for correct installation?

Centre the servo, check toe and steering endpoints, and do a slow speed run to confirm neutral steering. Make micro adjustments as necessary for symmetry.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved