Serpent 401037 Competition 1/10 Carbon Fibre Chassis for S400 S411  [SER401037]

Serpent SER401037 Chassis Carbon 2.5mm
Price:
£52.00
Brand:
Serpent
Model:
SER401037
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Carbon Fibre Chassis Built for S400 and S411

Replace the factory plate with the Serpent 401037 Carbon Chassis to gain a firmer, lighter main platform for the S400 and S411 models. The 2.5mm carbon fibre construction aims to stabilise the chassis under load and deliver repeatable handling through a range of track conditions.

Material Advantages

Using carbon fibre reduces overall flex while keeping weight down, which helps maintain consistent steering feel and tyre contact. The material also resists fatigue better than many composites used in stock plates.

Compatibility and Fitting

The Serpent 401037 Carbon Chassis is cut to suit S400 and S411 layouts and replaces the standard plate with minimal hassle. Typical installation requires basic tools and a careful check of screw lengths to protect the carbon edges.

Does this chassis need extra bracing?

In most cases no additional bracing is required. The Serpent 401037 is designed to work with the stock mounting points, though some teams add reinforcement in high stress areas for heavy use.

Can I use the chassis on tarmac circuits?

Yes. The increased stiffness helps on high grip surfaces, but you may need to soften other chassis settings to suit the higher traction environment.

Is it safe to drill extra holes?

You can drill or trim for customised mounting, but use appropriate bits and tape the cut lines to reduce the risk of splintering or delamination.

What torque should I use on mounting screws?

Use a light to moderate torque and avoid overtightening. Tighten incrementally and check that screw heads do not crush the carbon around the holes.

How do I protect the chassis finish?

Clean with mild soap and water and avoid abrasive cleaners. Consider edge protection or clear tape in high wear zones to keep the finish looking sharp.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved