Serpent 401039 Front Carbon Shock Tower - S400 S411 Race Spec  [SER401039]

Serpent SER401039 Shock Tower Carbon Front
Price:
£9.56
Brand:
Serpent
Model:
SER401039
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Precision Front Shock Tower in Carbon

Serpent 401039 is a carbon front shock tower engineered for the S400 and S411 platforms to sharpen handling and maintain alignment under load. It is aimed at drivers who fine tune their suspension for consistent performance.

Why Choose Carbon for the Shock Tower

Carbon provides a rigid but light solution that limits chassis flex and helps the suspension behave predictably. Fitting the Serpent 401039 can reduce small geometry shifts that cost time over a race distance.

Compatibility and Installation Notes

Made to match S400 and S411 factory mounting geometry, the tower installs with common hardware and should not require cutting or spacing. Always check hole alignment before fully tightening to protect the part.

Will this suit both carpet and asphalt racing?

Yes, the tower improves stiffness for different surfaces. You may still need to adapt shock valving and springs to match the grip and bump characteristics of each surface.

Should I pair this with other carbon parts?

Pairing with other carbon components can further reduce flex, but changes to multiple parts will likely require a full setup review to keep balance and handling consistent.

How do I check for damage after a crash?

Visually inspect for cracks or delamination and run a finger along edges to feel for rough spots. Replace the tower if any structural compromise is found rather than attempting repairs.

Does the Serpent 401039 require special packing for shipping?

Carbon parts are best shipped with foam or cardboard protection to prevent impacts. Retailers typically package the Serpent 401039 with adequate padding to avoid shipping damage.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved