Serpent 401740 Vertical Topdeck Mount - Precision Touring Car Upgrade  [SER401740]

Serpent SER401740 Vertical Topdeck Mount 4X
Price:
£21.06
Brand:
Serpent
Model:
SER401740
Condition:
Brand New
Write a review

Upgrade Chassis Rigidity on Project 4X

The Serpent 401740 Vertical Topdeck Mount is made to increase the structural stiffness of the Project 4X Touringcar. Intended for the 190mm EP variant, this mount provides a solid foundation for more accurate setup changes.

Race-Proven Tuning Benefits

By reinforcing the upper section of the chassis the mount reduces unwanted flex and improves steering consistency. That makes fine tuning more effective and repeatable across practice runs.

Compatibility Notes and Installation

This mount is built to suit the Serpent Project 4X platform, in particular the Touringcar EP 190mm. Installation follows the stock mounting points and is straightforward for an experienced hobbyist.

Specifications

  • Compatibility: Project 4X Touringcar EP 190mm
  • Material: High-strength composite
  • Function: Enhances chassis rigidity and tuning precision

Does this improve tyre life or just handling?

The mount primarily improves chassis behaviour and handling consistency. Better handling can indirectly lead to more even tyre wear, but tyre selection and setup remain key.

Can I fit this without modifying the chassis?

No chassis modification is normally required if you are fitting to the intended Project 4X Touringcar EP 190mm layout. Always confirm hole alignment before tightening hardware.

Will this affect corner entry feel?

Yes, increased topdeck stiffness typically sharpens corner entry and gives a firmer front response. You may need to adjust front roll characteristics to balance the change.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved