Serpent SER401768 19.5mm Pullrod Set for 4X EVO - Tuners Choice  [SER401768]

Serpent SER401768 Pullrod 19.5mm 4X EVO (4)
Price:
£4.15
Brand:
Serpent
Model:
SER401768
Condition:
Brand New
Write a review

Precise Suspension Links for the 4X EVO

Serpent SER401768 19.5mm pullrods are specified for the 4X EVO to ensure the suspension linkages remain accurate and reliable. These components are key to achieving steady, repeatable handling at varying track speeds.

Advantages of Using 19.5mm Pullrods

Maintaining the 19.5mm length preserves intended arm geometry and roll behaviour, helping the car deliver predictable turn-in and traction use. That makes setup changes more transparent when tuning for different circuits.

Best Practices for Fitting and Service

Tighten the Serpent 19.5mm pullrods to remove play while avoiding stripped threads. Check them during routine maintenance and swap any that show bends, thread wear or damaged ball connections.

Do these come in other lengths for the 4X EVO?

This listing is for the 19.5mm spec suited to standard 4X EVO geometry. Alternative lengths would require checking how they alter suspension angles and handling.

What checks should I perform after installation?

After fitting, ensure there is no lateral play and perform a short test run to confirm steering response. Reinspect threads and ball connections after initial use.

Will worn pullrods affect lap times?

Yes, worn or bent pullrods can introduce inconsistent steering and reduced predictability, which may hurt lap consistency. Replace suspect parts to keep performance steady.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved