Serpent SER401791 Project 4X PRO Rear Wheelhub 3-Point Set L and R  [SER401791]

Serpent SER401791 Wheelhub Rear 3 point Left + Right 4X PRO
Price:
£7.77
Brand:
Serpent
Model:
SER401791
Condition:
Brand New
Write a review

Wheelhub Upgrade for Consistent Rear Performance

The Serpent SER401791 wheelhub is made for the Project 4X PRO family. Supplied as left and right units, it represents a practical replacement or upgrade to refine rear-end behaviour.

Engineered for Even Load Handling

The three-point configuration helps distribute cornering forces so the rear end behaves more predictably. That design supports steadier throttle application and cleaner exits.

Compatibility Guide and Fitting Advice

This hub is compatible with the Project 4X PRO EP (SER400032) and installs using the usual RC toolset. Follow standard fitting practice and check fastener torque after initial running.

Does the SER401791 need any modifications to fit?

No modifications are normally required for Project 4X PRO installs. Always verify model compatibility and inspect parts before final assembly.

Are there recommended checks after installation?

Check wheel bearing condition, secure mounting hardware and perform a test run to confirm alignment and handling. Re-torque fasteners after initial use.

Will changing to these hubs require setup changes?

Some drivers adjust toe or camber when swapping hubs to fine tune balance. Start with your baseline setup and make small adjustments to suit driving style.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved