Serpent SER401880 X20FWD Lightweight Aluminium Chassis  [SER401880]

Serpent SER401880 Chassis Aluminium X20FWD
Price:
£85.19
Brand:
Serpent
Model:
SER401880
Condition:
Brand New
Write a review

Upgrade Plate for X20FWD Chassis

The Serpent SER401880 Aluminium Chassis is crafted for the Medius X20 FWD 1/10 EP models to enhance torsional rigidity and improve long term durability. The aluminium plate provides a stable baseline for set up work and tighter handling characteristics.

Sharper Control and Stability

Lowered centre of gravity and refined mass distribution from this chassis help the X20FWD track truer through corners and respond more evenly under power. The SER401880 is aimed at drivers seeking consistent vehicle behaviour.

Compatibility Details and Fit Notes

This chassis is compatible with X20 FWD model references SER400035 and SER400036. Replacement is generally straightforward; check component clearances and mounting points during the swap to ensure correct alignment.

Will the aluminium chassis affect tyre wear?

Stiffer chassis can change load patterns on tyres, so monitor tyre wear after fitting and adjust toe and camber if you notice uneven wear.

Is any special preparation needed before installation?

Clean mounting surfaces and inspect screw threads. If desired, apply a small amount of thread locker to critical fasteners to prevent loosening in race conditions.

Does the SER401880 change the car's balance front to rear?

The plate may shift balance slightly depending on electronics placement; fine tuning of battery position and shock settings will restore the preferred handling balance.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved