Serpent SER401926 X20 '21 Competition Motormount  [SER401926]

Serpent SER401926 Motormount X20 \'21
Price:
£39.38
Brand:
Serpent
Model:
SER401926
Condition:
Brand New
Write a review

Install the Serpent SER401926 on X20 '21

Designed for the Medius X20 '21 MID 1/10 EP chassis, the Serpent SER401926 motormount gives a reliable mounting surface that helps maintain precise motor alignment. The part is manufactured to tight tolerances to support consistent setup across runs.

Why This Upgrade Matters

Keeping the motor firmly located reduces drivetrain vibration and the risk of gear misalignment. That steadiness translates into more predictable throttle control and fewer surprises in race conditions.

Simple Setup Hints

Fit the SER401926 using even pressure on mounting screws and verify gear mesh after installation. Periodic checks after early runs will confirm the mount remains secure and aligned.

Is the motormount hard anodised or treated?

Finish type can vary by production batch; inspect the part for coating and treat mounting surfaces as needed to prevent corrosion or galling.

Can this mount handle larger pinions?

The mount secures motor position, but larger pinions increase load on the drivetrain. Make sure your gearbox and motor bearings are rated for the chosen gear ratio.

Will fitting change gear mesh settings?

Any change to motor position can alter mesh, so always recheck and adjust the pinion-spur engagement after fitting the new mount.

What quick checks should I do after a race?

After a session, inspect fasteners, confirm mesh and look for any movement at the motor interface. Tighten or replace hardware if any loosening is detected.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved