Serpent 411206 4.5mm Ball Joint Set - Suspension Upgrade  [SER411206]

Serpent SER411206 Balljoint 4.5 (4)
Price:
£3.80
Brand:
Serpent
Model:
SER411206
Condition:
Brand New
2 Reviews
Write a review

Keep Your Suspension Tight with Serpent 411206

The Serpent 411206 4.5mm ball joint set is a handy component pack for maintaining tight suspension geometry. Precision sockets and balls help ensure repeatable setup and control on track or at the practice area.

Precision Engineering and Wear Resistance

These 4.5mm ball joints are produced to accurate tolerances to limit play and resist wear under load. The low friction contact helps maintain predictable steering and suspension feedback session after session.

Fits Multiple Serpent Chassis

Supplied as a set of four, the joints fit a number of Serpent models and make servicing quicker. Keep spares in your pit box for fast replacements between runs.

Quick Fit and Check Routine

Prior to fitment, clean the mounting points and inspect for damage. Fit the ball joints, run the car briefly, then recheck for any looseness to ensure secure operation.

 

Product Reviews
2 Reviews
rating
I have been buying from your company for over three years now and you the most professional site i buy from. You always deliver quickly and have a great range of products at excellent prices. Thank you very much and i am loyal customer because you are the
rating
Support is very well and the service is fast and provides instant responses.

Do these come as a matched set?

Yes, the pack contains four matching 4.5mm joints intended for use across relevant suspension and steering points, allowing consistent replacement across the car.

What signs indicate a failed joint?

Look for increased steering slop, uneven tyre wear, or visible cracks. Any significant movement in the socket or flattened ball surfaces are clear reasons to replace the joint.

Can I mix with other brand parts?

You can use compatible 4.5mm ball joints from other manufacturers if the geometry and seating match. Confirm dimensions and thread sizes before mixing parts.

How often should I inspect them?

Give them a quick check after any heavy impact and a routine inspection every few running sessions to spot wear early and avoid handling issues.

Is special grease recommended?

A small amount of light RC grease on the ball contact area can help reduce wear. Use only a touch to avoid attracting dirt which can accelerate abrasion.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved