Serpent 411247 Carbon Top Deck S100 LTR Performance Part  [SER411247]

Serpent SER411247 Top-deck Carbon S100
Price:
£46.75
Brand:
Serpent
Model:
SER411247
Condition:
Brand New
Write a review

Boost S100 Handling with Serpent Carbon Top Deck

The Serpent 411247 Carbon Top-Deck is designed specifically for the S100 LTR Pancar chassis. Produced from quality carbon fibre, it stiffens the chassis to improve precision and reduce unwanted flex during aggressive cornering. Its blend of lightness and strength suits competitors aiming for consistent handling.

Why Fit a Carbon Top Deck?

Carbon fibre brings a high stiffness-to-weight ratio, reinforcing key areas of the chassis without a heavy penalty. Fitted to the S100, this top-deck sharpens steering feel and helps the car respond more directly to setup changes and driver inputs.

Installation Tips to Maximise Gains

When fitting the Serpent 411247, tighten fixings evenly and confirm clearance with suspension and motor hardware. Test the assembly at low speed after fitting to check for any binding; a proper install reduces flex and improves cornering stability.

Is this compatible with modified S100 chassis setups?

It is intended for standard S100 LTR Pancar layouts. If you have modified suspension towers or altered mounting positions, double check measurements before assuming fitment.

Will the carbon deck affect tyre wear or handling balance?

By reducing chassis flex the deck can change how the car transfers load to the tyres. Expect a tighter handling feel and consider small suspension tweaks to re-balance the setup.

Can I use the original screws and hardware?

In most cases original hardware is fine, but inspect screws for wear and use suitable washers to spread clamping loads across the carbon to avoid point stress.

Does the top deck need any special maintenance?

Routine checks for cracks or loose hardware after races will keep performance reliable. Clean debris from mounting areas and replace any damaged fasteners promptly.

Will adding this deck require electronic remounting?

Most installations do not require moving electronics, but if your layout is tight you may need to adjust servo or ESC positions to maintain good cable routing and clearances.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved