Serpent SER411412 Precision Aluminium Rear Axle Holder for F110 SF4  [SER411412]

Serpent SER411412 Rear axle holder L Aluminium F110 SF4
Price:
£15.39
Brand:
Serpent
Model:
SER411412
Condition:
Brand New
Write a review

Durable Rear Axle Support for F110 SF4

The Serpent SER411412 rear axle holder is a precision aluminium replacement that strengthens the rear assembly of the F110 SF4. Its solid construction helps protect the axle mounting area from deformation and wear during competitive use.

Key Advantages of the SER411412

Designed specifically for the Serpent F110 SF4, this aluminium holder provides a more robust alternative to plastic parts, increasing resistance to wear and maintaining consistent handling as parts age.

Assembly Advice for Trackside Adjustments

Fitting the Serpent SER411412 requires common RC hand tools and only a short workshop session. Double check screw tightness after initial running and recheck alignment after impacts to keep the rear end reliable.

Yes, the Serpent SER411412 is intended as a direct aluminium replacement for the original rear axle holder on the F110 SF4, fitting the same mounting points.
Adding aluminium increases stiffness at the rear and may slightly alter balance. Most users see improved stability rather than a negative shift in balance.
Often the original fasteners can be reused, but inspect them for wear and replace any that are stripped. Ensure they are tightened correctly to avoid movement.
Aluminium is durable but should be kept clean and checked for nicks or deformation after impacts. Light corrosion is rare, but keep mating surfaces free of grit.
After fitting, run a few short tests to verify there is no binding and that the axle spins freely. Recheck suspension geometry and make small adjustments as needed for best handling.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved