Serpent 500131 Rear Bulkhead for SRX2 RM Chassis - Replacement Part  [SER500131]

Serpent SER500131 Bulkhead Rear SRX2 RM
Price:
£5.15
Brand:
Serpent
Model:
SER500131
Condition:
Brand New
Write a review

Serpent 500131 Rear Bulkhead for Consistent SRX2 RM Handling

The Serpent 500131 Rear Bulkhead helps reclaim original rear chassis alignment on the SRX2 RM, making it a sensible replacement when preparing for racing or regular running. It supports stable rear behaviour by keeping suspension mounting points accurate.

Precision Location and Structural Support

This bulkhead secures the rear suspension geometry and contributes to the chassis rigidity required for repeatable handling. Serpent focuses on well-defined locating points to limit unwanted movement during aggressive driving.

Compatibility Notes and Fitting Guidance

Specified for the Serpent SRX2 RM chassis, the bulkhead fits the factory mounting layout for a clean installation. Swap it in when signs of wear appear, and follow standard reassembly checks to confirm alignment.

After fitting, verify suspension geometry and toe settings. Most repairs return the car to its previous setup, but small tweaks may be needed.
No special bedding is required. Ensure fasteners are torqued to spec and check for any binding in suspension movement after installation.
Yes, stripped or stretched fasteners can lead to poor clamping. Replace worn screws when fitting a new bulkhead to maintain secure mounting.
The bulkhead fits the SRX2 RM stock layout. If your build uses modified geometry components, double check clearances and alignment before final installation.
Inspect the suspension mounting points, bearings and adjacent chassis sections for cracks or elongation of holes to prevent repeat failures.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved