Serpent 500542 - SRX2 Rear Long Driveshaft Set Club Racer Fit  [SER500542]

Serpent SER500542 Driveshaft Rear Long (2) SRX2
Price:
£17.16
Brand:
Serpent
Model:
SER500542
Condition:
Brand New
Write a review

Improve SRX2 drivability with Serpent 500542 components

Racers seeking a dependable upgrade can fit the Serpent 500542 - SRX2 Rear Long Driveshaft Set to enhance drivetrain durability and reduce unwanted flex. The set is matched to SRX2 parts for consistent power transfer to the rear axle.

Reliable Construction for Competitive Running

These rear long driveshafts are produced to endure the stresses of club competition, offering a dependable component that helps the SRX2 stay predictable under acceleration. Their build quality supports steady lap times and fewer mechanical worries.

Simple Installation for Fast Turnaround

Designed for direct installation on the SRX2, the driveshafts allow quick replacement with standard RC tools. This helps keep setup time low between practice and race sessions.

How do I check alignment after fitting new driveshafts?

Rotate the drivetrain by hand and observe for binding or wobble; ensure wheel hub runout and axle positions match the original geometry.

Can these driveshafts handle wet track conditions?

They are robust enough for damp conditions, but regular cleaning after wet runs is recommended to prevent grit ingress and corrosion.

Is any break-in required for these parts?

A short check-run to confirm fit and to seat interfaces is useful, but no extensive break-in procedure is necessary beyond routine inspection.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved