Serpent 500551 Rear Suspension Bracket for SDX - Club and Race  [SER500551]

Serpent SER500551 Suspension Bracket Rear-Rear SDX
Price:
£20.73
Brand:
Serpent
Model:
SER500551
Condition:
Brand New
Write a review

Upgrade Your SDX Rear End with the Serpent 500551 Bracket

The Serpent 500551 Rear Suspension Bracket is crafted for the SDX family to deliver firmer rear support and more predictable handling. Made from a high-strength alloy, this bracket helps the rear assembly resist deformation so the vehicle maintains intended geometry during high-load maneuvers. It is a practical replacement for racers seeking steadier rear performance.

Specifications

  • Compatibility: SDX Series
  • Material: High-strength alloy
  • Function: Enhances stability and handling

A solid option for racers and hobbyists aiming for durable, repeatable handling improvements, the Serpent 500551 Rear Suspension Bracket is a worthwhile SDX upgrade.

Does this bracket require chassis modification to install?

No chassis alterations are normally necessary; the Serpent 500551 fits standard SDX rear mounting points and uses the same fixings as the original part.

Will this change my car handling on low-grip surfaces?

The increased rear stiffness can make handling more consistent on low grip, but you may need to soften rear damping or adjust anti-squat for the best balance.

Are there recommended fasteners or torque settings?

Use the original SDX fasteners where possible and tighten to manufacturer torque ranges; check bolt security after the first runs.

Does the bracket affect suspension tuning options?

Yes, with a stiffer rear mount you may notice different shock responses; small adjustments to spring rate or damping can restore preferred handling.

What routine checks should I do after races?

After sessions inspect the bracket and mounting bolts for wear or loosening, and make any minor setup tweaks based on lap feedback.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved