Serpent 500583 Slipper Adjust Nut for SDX Chassis - Performance Upgrade  [SER500583]

Serpent SER500583 Slipper Adjust nut SDX
Price:
£7.77
Brand:
Serpent
Model:
SER500583
Condition:
Brand New
Write a review

Serpent 500583 Slipper Adjust Nut - SDX Chassis Tuning

The Serpent 500583 Slipper Adjust Nut is intended for use with the SDX chassis to allow precise control of slipper clutch preload. It helps model engineers fine tune engagement for more predictable handling.

Better Balance Between Power and Grip

By adjusting the slipper nut you can alter how much drive is allowed before slip occurs, improving traction management through corners and on exits. That control is useful in tight race conditions.

Engineered for Longevity

Produced from sturdy materials with accurate threads, the Serpent 500583 resists wear from frequent adjustments and keeps setup changes consistent over time. It is a dependable part for regular racers.

Will adjusting the nut affect handling immediately?

Yes, even small changes can shift launch behaviour and mid corner traction, so make gradual adjustments and test each change.

What thread care is recommended?

Keep threads free of grit, apply a little light oil for smooth action, and inspect for burrs that could affect seating.

Can I tune this for wet conditions?

Yes, increasing slip slightly can prevent abrupt power transfer on slippery surfaces, improving control in damp conditions.

Does it require periodic replacement?

Inspect it periodically; replacement is only needed if threads are damaged or if adjustment becomes imprecise after heavy use.

Any quick setup tips for racing day?

Start with a baseline setting from previous events, make small changes between practice runs, and keep notes so you can repeat a successful setup.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved