Serpent 500643 SRX2 MH Precision Brass Suspension Bracket  [SER500643]

Serpent SER500643 Suspension Bracket SRX2 MH Rear Front Brass
Price:
£33.55
Brand:
Serpent
Model:
SER500643
Condition:
Brand New
Write a review

Precision Brass Bracket for SRX2 MH Balance

The Serpent 500643 SRX2 MH Brass Suspension Bracket offers a direct replacement for the aluminium mount to introduce deliberate rear ballast on the Spyder SRX2 MH. It lets drivers adjust the vehicle's weight distribution to suit circuit demands and personal setup preferences.

Improved Cornering and Grip

Installing the brass bracket increases mass at the mounting point, promoting better rear traction and helping the car rotate more predictably through corners. This change can aid consistency and confidence at the limit.

Fast Fit and Practical Tuning

Manufactured for a bolt-on fit, the bracket is simple to install with standard tools. After fitting, try small incremental setup changes to springs or diffs to fully exploit the handling differences.

Will the brass unit require drilling or trimming?

No. The Serpent 500643 is produced to match the SRX2 MH mounting points and installs without additional work.

Should I expect changes in lap consistency?

Many drivers find consistency improves as the rear becomes more planted, though you should test to see how it interacts with your setup and track conditions.

Is this suitable for club racing and practice?

Yes. It is a straightforward upgrade for both practice sessions and competitive events where weight balance matters.

Any maintenance advice after fitting?

Check the mounting screws for tightness after initial runs and inspect for any contact with nearby components; re-tighten as part of routine setup checks.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved