Track-Focused Front Shafts Serpent 500859 - 76mm DJC Driveshaft Set for SRX4 Gen3 [SER500859]

Price:

£20.82

Brand:

Serpent

Model:

SER500859

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Balanced Driveshafts for Reliable Lap Times

The Serpent 500859 DJC Driveshaft Front 76mm set is aimed at improving drivetrain consistency and service life on SRX4 Gen3 cars. Part of the Spyder Series range, the shafts support clean power transfer and dependable rotation under race conditions.

Consistent Performance from a Double Joint Setup

The double joint design lowers joint friction and helps keep torque delivery smooth during corner exits. With the exact 76mm length, compatibility with SRX4 Gen3 is maintained for correct suspension and steering geometry.

Specifications

Length: 76mm
Compatibility: SRX4 Gen3
Material: High-strength steel
Quantity: Set of 2

How do I know if these are worn?

Check for play at the joint, uneven spin or noise under load. Any visible deformation or excessive looseness means replace the shaft to avoid further damage.

Are these compatible with standard SRX4 Gen3 hubs?

They are made to match SRX4 Gen3 hub spacing and should work with standard hubs, but always confirm axle engagement depth and clearances during fitting.

What routine checks should I perform?

After each run inspect joint seals, clear out grit, and reapply a small amount of suitable grease. Tighten fixings and verify there is no axial movement in the assembly.